The cutting machine is the same as a car, also needs some daily maintenance after some months. So how to maintain the hydraulic cutting machine? Here are some tips some you.
First, replace the hydraulic oil.
The cycle of changing the hydraulic oil is about 1 year (of course, you can also shorten or extend it according to your actual use situation), and clean the fuel tank and filter while changing the hydraulic oil. And please choose a large-brand #46 hydraulic oil.
Second, remove the dust.
Removal of dust and residue should be performed daily (electrical dust should be handled by professionals), after the machine is completely turned off. and paying special attention to sliding and rotating parts.
Third, tighten the bolts.
Fastening bolts is a very important part of the maintenance. Loose bolts will be easy to break and cause bigger problems or accidents, so please do this work carefully (we recommend to do one inspection every three months).
Fourth, check the lubrication system
The sliding and rotating parts of the cutting machine need to be filled with lubricating oil, and good lubrication is necessary, so please check the automatic lubrication system regularly.
Fifth, check the parallelism of the table.
In fact, it is impossible to cut in the center of the cutting machine with the cutting dies every time. Long-term off-center cutting will make the cutting machine parallelism worse, which accelerates the wear of the die and the cutting board. Regularly check the parallelism of the machine, you can master the parallelism situation at any time and adjust the cutting position of the die and correct the unevenness accordingly so that the cutting machine can be used longer with the best performance.